文章摘要
张婷婷,董珈豪,王蒙,韦良强,秦舒浩.分散相含量对乙烯-醋酸乙烯酯共聚物/聚丙烯原位微纤复合材料微纤形态、结晶行为及流变和力学性能的影响[J].材料导报,2018,32(12):2032-2037
分散相含量对乙烯-醋酸乙烯酯共聚物/聚丙烯原位微纤复合材料微纤形态、结晶行为及流变和力学性能的影响
Dispersed Phase Content of Ethylene-vinyl Acetate Copolymer/Polypropylene (EVA/PP) In-situ Microfibrillar Composites (MFCs):Influences to Microfiber Morphology, Crystallization Behavior, Rheological and Mechanical Properties
  
DOI:10.11896/j.issn.1005-023X.2018.12.017
中文关键词: 微纤形态 力学性能 结晶行为 流变性能 分散相 乙烯-醋酸乙烯酯(EVA)共聚物 聚丙烯 微纤复合材料(MFCs)
英文关键词: microfiber morphology, mechanical properties, crystallization behavior, rheological properties, dispersed phase, ethylene-vinyl acetate (EVA) copolymer, polypropylene, microfibrillar composites (MFCs)
基金项目:国家自然科学基金(51363002)
作者单位E-mail
张婷婷 贵州大学材料与冶金学院,贵阳 550025
国家复合改性聚合物材料工程技术研究中心,贵阳 550014 
qinshuhao@126.com 
董珈豪 国家复合改性聚合物材料工程技术研究中心,贵阳 550014  
王蒙 贵州大学材料与冶金学院,贵阳 550025
国家复合改性聚合物材料工程技术研究中心,贵阳 550014 
 
韦良强 国家复合改性聚合物材料工程技术研究中心,贵阳 550014  
秦舒浩 贵州大学材料与冶金学院,贵阳 550025
国家复合改性聚合物材料工程技术研究中心,贵阳 550014 
qinshuhao@126.com 
摘要点击次数: 2231
全文下载次数: 0
中文摘要:
      利用微纳层叠共挤出装置成功制得EVA/PP原位微纤复合材料(MFCs),并对其微纤形态、力学性能、结晶性能和流变行为进行了研究。结果表明:PP在EVA中能够形成微纤,且随PP含量增加,直径较大的微纤数量显著增多,MFCs的储能模量(G′)和损耗模量(G″)都相应增大。且当PP含量低于10%(质量分数,下同)时,复合材料体系是部分相容的,但当PP含量超过10%时,体系发生相分离现象。PP微纤能够有效提高EVA的拉伸强度。当PP含量为20%时,拉伸强度最大,为16.71 MPa, 比纯EVA树脂提高了42.9%。差示扫描量热法(DSC)测试显示PP微纤会阻碍EVA的结晶行为,使MFCs的结晶度降低。
英文摘要:
      A series of ethylene-vinyl acetate copolymer/polypropylene (EVA/PP) in-situ microfibrillar composites (MFCs) differed in dispersed phase (i.e. PP) content were prepared using a multistage stretching extruder with an assembly of laminating-multiplying elements (LMEs), and the products’ microfibers morphology, crystallization behaviors, mechanical and dynamic rheological performances were studied. The results showed that PP could form microfibers in situ in EVA, and more PP content would lead to obviously more large-diameter microfibers and higher storage modulus (G′) and loss modulus (G″) of the MFCs. The systems with PP contents below 10wt% were partially compatible, while the phase separation occurred in systems with PP contents over 10wt%. PP microfibers could enhance the tensile performance of EVA effectively, as the EVA/20wt%PP MFCs owned the maximum tensile strength of 16.71 MPa, which was 42.9% higher than that of pure EVA. We also observed an obstructive effect of PP microfibers on the crystallization behavior of EVA, which consequently attenuates the crystallinity of the MFCs.
查看全文   查看/发表评论  下载PDF阅读器
关闭